View Single Post
Old November 16, 2012, 08:48 PM   #14
Bob Wright
Senior Member
 
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 1,815
Tennjed said:
Quote:
Thanks Bob, is it something that would normally need to be done by a gunsmith?

Depends on a couple of factors. Brass frames can be fitted with careful use of file, emery paper and/or Flitz metal polish, if any fitting is in fact needed. Stainless steel easy also. Blued steel needs to be polished and reblued.

Some swaps are simple remove/replace propositions, some require fitting, maybe thinning down to match frame thickness.

Most Ruger take-off frames (from another Ruger) are simple switches. New frames, especially carbon steel, are oversize and in-the-white, need fitting, polishing and blueing.

Bob Wright
Bob Wright is offline  
 
Page generated in 0.04536 seconds with 7 queries