View Single Post
Old November 16, 2012, 01:32 PM   #2
45_auto
Senior Member
 
Join Date: November 21, 2011
Location: Southern Louisiana
Posts: 619
It's possible to reproduce any part. After all, they were machined originally. The question is whether it's worth the money when it's costing you $100/hour.

The design (dimensions and allowable tolerances) and setup (possibly special tooling) is what takes the longest. The actual machining is usually a minimal part of the job.
45_auto is offline  
 
Page generated in 0.04254 seconds with 7 queries