View Single Post
Old November 16, 2012, 12:19 AM   #12
GWS
Senior Member
 
Join Date: September 8, 2010
Location: New Mexico
Posts: 462
Both problems are usually due to an interruption in rhythm where you leave a primer loose above the strip and not inserted. Be careful not to let the press handle go past neutral and end up pushing a primer up when you don't want it up. Learning curve. Pay special attention to this when using small primers, because they are easier to get turned than large primers.
__________________
THR's GW Starr & Arfcom's GWhis is me. Wasn't smart enough to see the advantage of one signature across forums when I joined.--GWS
GWS is offline  
 
Page generated in 0.05456 seconds with 7 queries