View Single Post
Old November 15, 2012, 01:08 PM   #28
stev32k
Junior Member
 
Join Date: November 8, 2012
Posts: 10
My LNL is back at the factory right now. It would not stay adjusted and cases would hit the side of the sizing die or miss the primer hole. I could adjust the pawls and get it dead on then 5 or 10 strokes later it would be off again. Got to be on a first name basis with the Hornady CS guys.

I managed to load 100 9mm and 100 .40 S&W, but it took almost 4 hours and was kinda painful. I had to check the adjustment of the shell holder plate on every stroke else a case would hit the sizing die or miss the primer.

Finally Hornady said to box it up and send it back. It arrived at the factory today. I hope they tell me what was causing the problem so maybe I can do something about it if it happens again.
stev32k is offline  
 
Page generated in 0.04392 seconds with 7 queries