View Single Post
Old November 13, 2012, 08:49 PM   #19
Senior Member
Join Date: September 15, 2007
Posts: 600
Sounds good, as long as it doesn't affect reliability. I'd be open to any guidance as to how to do this for my AK (using a spare gas tube of course).
Never tried the mod on a AK but you can probably regulate the bolt speed and ejection pattern buy using cast bullets and a powder like 4895. Thats basically what I do with my Chinese SKS it cycles with a very low pressure curve only requiring 12.5 grs. of Alliant 2400 and a 170 gr. Lee gas check cast bullet drops the brass right at my feet,MV runs about 1450 fps. on the chrono.

Here is the thread If you PM Mr. Gibson he will probably provide you with some photos of the mods.

Last edited by res45; November 13, 2012 at 08:58 PM.
res45 is offline  
Page generated in 0.07374 seconds with 7 queries