View Single Post
Old November 13, 2012, 02:01 PM   #12
jwrowland77
Senior Member
 
Join Date: March 23, 2012
Location: Conway, Arkansas
Posts: 967
This is why I have a dowel rod cut for a smaller piece, then after powder I check each case to ensure that the line I marked on it is right at the top of the case. If its below, then no/low charge, above then its double/over charge. Haven't gone wrong with it yet.

Congrats though on finding it before things got ugly though.
jwrowland77 is online now  
 
Page generated in 0.04727 seconds with 7 queries