View Single Post
Old November 11, 2012, 07:23 PM   #32
Prof Young
Senior Member
 
Join Date: August 21, 2007
Posts: 638
Start with a powder measure and scale not dippers.

Loaders:
I used lee dippers when I started and while it was mostly okay, i had a few squibs and I was limited to the powders that I could find a dipper equivalent for.
Now that I'm using a scale and powder measure I'm learning that some of the dippers actually have fewer grains of powder than the minimum suggested loads in the books.

Now, I usually load somewhere in the middle between the minimum and maximum suggested loads. Can't do that with dippers, unless you custom make your own.
Prof Young is offline  
 
Page generated in 0.04516 seconds with 7 queries