View Single Post
Old November 11, 2012, 12:51 PM   #3
chris in va
Senior Member
 
Join Date: December 26, 2004
Location: Louisville KY
Posts: 12,513
I had a decocker model for ten years. If i had to do it all over again, it would be a polished stainless with the safety. You can always decock the hammer to the half notch position by hand, no biggie.

That being said you may want to consider the updated version, the SP01. It has a few upgrades from the older 75 design. Or also have a close look at the P01 if you even think conceal carrying might happen in the future. It's still a fantastic range gun.

One more thing. Don't be discouraged by the hard DA pull. It's easily remedied by swapping out the hammer spring with a 15# from Wolff. Also a used CZ will be smoother than a new one so don't hesitate to find a preowned.
chris in va is offline  
 
Page generated in 0.04357 seconds with 7 queries