View Single Post
Old November 10, 2012, 08:38 PM   #12
Cheap 870
Junior member
 
Join Date: November 12, 2011
Location: Ohio
Posts: 159
Well I received my springs yesterday so decided to do my trigger job today.
While I had the gun apart I polished everything that needed polished.
I'm gonna start with the 10lb. hammer spring & see how it shoots. I left the stock trigger return spring in but did take it out & clean up the inside where the spring goes.
I have to say that before I did this the double action pull felt grity & was defenetly harder to pull. Now it's smooth & lighter.
I haven't had a chance to shoot it yet but I'll let you know if any miss fires occure.
This was the best instruction I found on how to do the trigger job.
http://www.teslamap.com/public/sp101...job/index.html
Cheap 870 is offline  
 
Page generated in 0.04432 seconds with 7 queries