View Single Post
Old November 10, 2012, 02:02 PM   #25
SEHunter
Senior Member
 
Join Date: October 6, 2009
Posts: 221
After these posts, im not as set on neck sizing as i was. I do understand that i dont want to push the shoulder back when FL sizing but if the brass gets to the point where i want to push it back, i need to know how far by having my FL die correctly adjusted.

Stupid question- i ordered a head space guage from Brownells- how is this tool used correctly to adjust a full length die? Its the tool that the case fits into- not the tool that goes in the chamber to check head space. I had planned on using a fired case to make my head space measurement.
SEHunter is offline  
 
Page generated in 0.04265 seconds with 7 queries