Thread: H&R 999
View Single Post
Old November 9, 2012, 05:23 PM   #1
cruiser00
Junior Member
 
Join Date: March 7, 2012
Posts: 4
H&R 999

I have an H&R 999 that works good except for a couple of problems. The barrel latch on the top of the revolver works loose after firing a couple of rounds and has to be pushed back into place each time. The second problem is that the cylinder comes off the shaft when extracting empty rounds. I push it back on the shaft, turn it, and it locks back into position. I'm sure these problems are due to a couple of worn parts. Has anybody ever had these problems and which parts need to be replaced?
Attached Images
File Type: jpg 100_3400.JPG (50.9 KB, 25 views)
File Type: jpg 100_3402.JPG (59.1 KB, 21 views)
File Type: jpg 100_3404.JPG (59.1 KB, 19 views)

Last edited by cruiser00; November 10, 2012 at 05:18 PM.
cruiser00 is offline  
 
Page generated in 0.05049 seconds with 8 queries