View Single Post
Old November 7, 2012, 02:50 PM   #14
hounddawg
Senior Member
 
Join Date: March 1, 2009
Posts: 760
I used to have that problem. To determine where my problem was I took a flared and de primed case with no powder and adjusted my seating die until that case would fit into and come out of my barrel easily, then took bullet and placed it into a un primed case that had been flared but had no powder and started with the recommended COAL and slowly shortened it until the case would pass the plunk test as you call it. It all had to do with the ogive of the bullet I was using.

ogive
Quote:
Bullet Ogive – bullet ogive is defined as the “curve of a bullet’s forward section”. . .
http://blog.sinclairintl.com/2009/03...seating-depth/

seems as if this is a common problem we all run into
__________________
Government is like a baby. An alimentary canal with a big appetite at one end and no sense of responsibility at the other. - Ronald Reagan

Last edited by Unclenick; November 11, 2012 at 08:59 AM. Reason: See board policy on posting copyrighted materials.
hounddawg is offline  
 
Page generated in 0.04254 seconds with 7 queries