View Single Post
Old November 7, 2012, 02:04 AM   #11
Sport45
Senior Member
 
Join Date: May 25, 1999
Location: Too close to Houston
Posts: 4,087
Is the FCD set so that it touches the shell holder at the top of the stroke? Do you feel much resistance pushing the cartridge through?

I'm surprised to hear you are having chambering issued after running through the FCD. Most who complain say the FCD swages their cast bullet because the sizing ring is too small. In any case, you probably don't need to adjust the crimp as long as you are removing the bell produced by the expander.

Paint a sticking case with magic marker and see where it's draaging in your case gauge.
__________________
Proud member of the NRA and Texas State Rifle Association. Registered and active voter.
Sport45 is offline  
 
Page generated in 0.04591 seconds with 7 queries