View Single Post
Old November 6, 2012, 04:43 PM   #22
brigond
Member
 
Join Date: October 28, 2012
Location: PA
Posts: 47
I'm loading 9 mm using .356 diameter lead round nose bullets. They chamber and fire in my sr9c . When I send them through my cartrage gauge most don't drop even . Im thinking its the bulge and the .356 diameter of the lead round. Any thoughts on what I can do to improve this? I guess one way may be going to a plated or FMJ but I have a thousand of these bullets and I'm gonna use them. Also , those of you using lead bullets. I noticed that some of these lead bullets have a seam on them . The seam is right down the center where I guess 2 mold halves met. Normal? Or bad fit and finish? I assume this affects accuracy considerably. I'm going to post this lead bullet question on a new thread.

Last edited by brigond; November 6, 2012 at 07:31 PM.
brigond is offline  
 
Page generated in 0.04923 seconds with 7 queries