View Single Post
Old November 5, 2012, 09:54 PM   #1
4T4MAG
Senior Member
 
Join Date: April 28, 2009
Posts: 143
Choate Tactical Rifle Stock

Has anyone ever removed material from a Choate rifle stock to lighten it up a bit? The butt is hollow, the majority of weight is forward and with a heavy bull barrel it makes for one tipsy rifle. Could I possible mill some .25 horizontal or vertical lines in the barren channel or on the outside of the fore end? Or not drill out the plastic at all, just drill holes underneath the aluminum track for the sliding swivel? Would this amount to much weight reduction at all? The stock is heavier than my, well it's heavy.

Last edited by 4T4MAG; November 5, 2012 at 10:05 PM.
4T4MAG is offline  
 
Page generated in 0.04130 seconds with 7 queries