View Single Post
Old October 29, 2012, 10:49 AM   #20
brigond
Member
 
Join Date: October 28, 2012
Location: PA
Posts: 47
Ok, this is important. I have been taking measurements of the grains with the .40 cc hole . After I fixed the powder leakage as described above . I am now getting a different reading . Previously , before the fix, I was getting a 4.5 to 4.6 grain reading from the .40 cc hole. Now, after the powder leak fix I'm getting a consistent 4.3 grain reading from the .40 cc hole. The good part is that the powder is no longer leaking from under the hopper. Now I have to start over in recording the measurements from each disc hole. The important part is that the fix has changed the grain readings of the disc holes.
brigond is offline  
 
Page generated in 0.04771 seconds with 7 queries