View Single Post
Old October 29, 2012, 03:41 AM   #1
rajbcpa
Senior Member
 
Join Date: August 27, 2012
Posts: 315
Fitting a conversion cylinder?

This is a peitta new Army C&B. The issue is getting the cylinder pin to fully insert into the rear of the frame with the new conversion cylinder and cylinder ring in place.

I have removed material from the new cylinder foot using a file and this has allowed me to fit both the cylinder and ring into the frame, however, the cylinder pin does not insert into the rear hole in the frame.

The directions state that if the cylinder pin cannot be inserted fully, remove material from the "screw" that is not allowing the cylinder pin to seat.

What is the "screw"? Is the screw in the frame or is the screw on the new cylinder?

There does not appear to be anything in the frame that is binding the pin from seating in the rear of the frame.

Thx...
rajbcpa is offline  
 
Page generated in 0.04667 seconds with 7 queries