View Single Post
Old October 28, 2012, 06:50 PM   #8
brigond
Member
 
Join Date: October 28, 2012
Location: PA
Posts: 47
Great, I'm going to see how the mid range charge that I'm getting with the .40 fairs ,when I get to the range. If I need to reduce the charge I will go the route of reaming the .37 cc hole. I always seem to get powder leaking on to the surface of the disc. It's not a big deal but its annoying since it gets messy. I tried tightening the screws to the hopper. Is this normal?

Last edited by brigond; October 28, 2012 at 07:29 PM.
brigond is offline  
 
Page generated in 0.04983 seconds with 7 queries