View Single Post
Old October 27, 2012, 11:13 AM   #3
Rangefinder
Senior Member
 
Join Date: August 4, 2005
Posts: 2,005
Here's a couple I've done reciently so you can get some idea how the traditional "spud" in a HP mold works and some of the options you may have.

"Devastator" in .358




Same mold fitted with an adjustable pin (sleeved to decrease pin diameter and give a little extra integrity to the nose). Pin can be adjusted to the rear lube groove for deep-cavity HP or backed out to nothing more than a dimple in the nose. (not the type of thing that happens at the factory, however)
__________________
"Why is is called Common Sense when it seems so few actually possess it?"

Guns only have two enemies: Rust and Politicians.
Rangefinder is offline  
 
Page generated in 0.05118 seconds with 7 queries