View Single Post
Old October 26, 2012, 04:59 PM   #9
spearpoint
Junior Member
 
Join Date: February 4, 2012
Posts: 3
"If you must single load these carbines, remove the bolt, install the round in the bolt face/extractor and reinstall the bolt and close."

This is potentially hazardous. Typically, it doesn't take much of a bump to retract the bolt head on these rifles. When this happens, the firing pin will protrude from the bolt face with full force...
spearpoint is offline  
 
Page generated in 0.03956 seconds with 7 queries