View Single Post
Old October 26, 2012, 09:59 AM   #14
rebs
Senior Member
 
Join Date: January 10, 2012
Posts: 2,240
I partially pulled the bullets on a few using a CH bullet puller. When I went to adjust the coal I measured a few and they were slightly over 2.255 so I tried to move them a few thousands with squeezing the caliber and I was able to move the bullet, just by hand. Now I am concerned that they maybe too loose and get bullet set back if I load a magazine and fire them in my AR. At this point I am thinking I should just pull the bullets, dump the powder in a scale pan, resize the cases and then put the powder back in and reseat the bullets. Its more work but bullet set back could raise pressures enough to ruin my day and my gun.
Thank you for all the replies but I am going to play it safe.
rebs is offline  
 
Page generated in 0.06105 seconds with 7 queries