Thread: Cleaning Dies.
View Single Post
Old October 25, 2012, 09:58 PM   #8
rodfac
Senior Member
 
Join Date: January 22, 2005
Location: Kentucky
Posts: 1,948
Mineral spirits is the cheapest method, WD40 works as well, .... a nylon or bronze bore brush .45 gets the tough stuff, then a cleaning patch to dry 'em out....If I do them once a year, it's a lot. Generally, I only need to get the bullet lube out of my seating dies for cast bullet shooting. The jacketed stuff doesn't need it, nor do the sizing dies. If you need to clean the sizers, then you're probably using too much case lube. Rod
__________________
Cherish our flag, honor it, defend what it stands for or get the hell out. Our Freedoms are not free, they've been paid for many times over by heros in uniform. Far better men than I, died that we could be FREE.

USAF FAC, 5th Spl Forces, An Loc, lll Corps, RVN, 69-70, Vietnam Vet '69-'73
rodfac is offline  
 
Page generated in 0.04170 seconds with 7 queries