View Single Post
Old October 25, 2012, 04:31 PM   #2
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,131
Take the gun in hand (make sure the pivot pin hole is clear) and whack the end of the barrel on the bench or a solid block of wood. The pivot pin should come out.

When re-assembling those guns, make sure the pivot pin spring fits over the projection on the cylinder stop before slipping the pivot pin over the spring. If the spring gets between the cylinder stop and the frame, the gun won't go together.

Jim
__________________
Jim K
James K is offline  
 
Page generated in 0.05057 seconds with 7 queries