View Single Post
Old October 25, 2012, 04:17 PM   #1
olmountain
Junior Member
 
Join Date: October 21, 2012
Posts: 5
Hi-Standard Sentinel link pivot pin removal

I raised this issue in the Revolver Forum but think it should have been here...sorry!

Trying to install the cylinder in a Sentinel R-101, I was unable to depress the "link pivot pin" (PN #7140) to slip the "crane assembly" into place. I tapped lightly on a punch to free up the pin, but not lightly enough because it not only freed up --- it slid all the way back into the frame and is now stuck there.

I have a fair background in automotive mechanical work but guns are new to me, so I'm afraid it may be time for professional attention. But first... any advice?
olmountain is offline  
 
Page generated in 0.04878 seconds with 7 queries