View Single Post
Old October 24, 2012, 03:02 PM   #5
K1500
Senior Member
 
Join Date: December 24, 2011
Posts: 158
Well, the spring on my Mossberg 590A1 got substantially easier to load or unload after it was left loaded for an extended period of time.

I am aware of the studies that say that springs do not wear out from compression, after they take their initial set. I believe leaving it loaded may help it take an initial set.

In addition, but those studies assume the spring is not deformed beyond its design limits. If any spring in a gun is at or past it's design limit, it is a tube mag spring.

Bottom line, it may not do anything, but it sure can't hurt. Clipping a couple of coils off can hurt. I would try the no harm option first.
K1500 is offline  
 
Page generated in 0.04162 seconds with 7 queries