Thread: 357 magnum dies
View Single Post
Old October 22, 2012, 11:12 PM   #18
joneb
Senior Member
 
Join Date: December 10, 2005
Location: Central , OR
Posts: 1,732
Quote:
The washer was close, but not exact,
What is width of the washer ? My 38spl brass is trimmed at 1.148" and my 357 mag brass is trimmed to 1.280" my RCBS supplied washer is .13" this close enough for the expander/flare die but I often use different bullets for these cartridges so adjustments are usually needed with the seat/crimp die anyway.

oops

Last edited by joneb; October 23, 2012 at 10:10 AM.
joneb is offline  
 
Page generated in 0.04710 seconds with 7 queries