Thread: 357 magnum dies
View Single Post
Old October 22, 2012, 04:56 PM   #15
David Bachelder
Senior Member
 
Join Date: August 23, 2011
Location: Trinity, Texas
Posts: 618
I also wound up buying an additional set of RCBS 38/357 dies. They are resting on the same turret head. The washer was close, but not exact, for me anyway.

Most of my dies are RCBS. Most of my lead casting equipment is LEE, including the majority of my bullet molds. I like the LEE six bangers, a long difficult learning curve, but once you get it .... no problem. Aluminum bullet molds like to be at just the right temp. Not too cold and not too hot. There is a thin line between frosty bullets and bullets with no wrinkles.
__________________
David Bachelder
Trinity, Texas
I load, 9mm Luger, 38 and 40 S&W, 38 Special, 357, 45ACP, 45 Colt, 223, 243 and 30-06
David Bachelder is offline  
 
Page generated in 0.04806 seconds with 7 queries