View Single Post
Old October 22, 2012, 12:48 PM   #1
akinswi
Member
 
Join Date: October 14, 2012
Location: Murfreesboro, TN
Posts: 46
New to Bullet Casting

Hello, I have been reloading for 10 years now and Im intrested in getting into bullet casting. Im getting fed up with paying high prices on manf bullets so was intrested in bullet casting. Im a novice at this so please excuse any ignorance I may have.

1. What is a typical size of a lead ingot and usually how much do they cost?
2. How many 44mag, 45acp bullets, 9mm bullets could I get out of an ingot?
3. Lead is pretty posionous any saftey measures you recommend.
4. last question how long would you say would it take to make 100 bullets

thanks.
akinswi is offline  
 
Page generated in 0.04376 seconds with 7 queries