View Single Post
Old October 20, 2012, 11:19 PM   #14
shortwave
Senior Member
 
Join Date: December 17, 2007
Location: SOUTHEAST, OHIO
Posts: 5,918
I agree with Webleymkv.

I just wouldn't be sanding/modifying a part on a brand new gun that I thought was the cause of the pistol malfunctioning or not operating properly unless I was told to do so from the manufacturer.
Unless I was willing to be okay with the manufacturer voiding my warranty.

Too, you said the slide would release almost on its own with the standard mag. before you started sanding on the release. You may have a hard time convincing the gunsmith at S&W of this if he/she realizes you have been sanding on the release.

Last edited by shortwave; October 20, 2012 at 11:25 PM.
shortwave is offline  
 
Page generated in 0.04369 seconds with 7 queries