View Single Post
Old October 18, 2012, 07:21 PM   #13
The_Covenant
Junior Member
 
Join Date: March 1, 2012
Posts: 7
Well guys, it looks like you were right about the resizing die not being set quite right. It was backed off a little too much. I re-sized a batch of 10 casings that were troublesome, after adjusting the sizing die. They trimmed right up. Wow.

Thank you guys so much for helping me out with this, I would have never thought of that.

Cheers!
The_Covenant is offline  
 
Page generated in 0.04084 seconds with 7 queries