View Single Post
Old October 18, 2012, 12:38 PM   #25
JohnnieBush
Junior Member
 
Join Date: October 9, 2012
Posts: 14
Pretty Good Call, Ben!

I could be wrong, but I think Picture 10 of 11 shows the guide-rod/recoil spring not seated all the way against the barrel.
Ben


Update:

I looked at the order in which my photos are displayed in Dropbox. The Photo that your are looking at (#10) is a photo that I took of the RSA (Retun Spring Assembly) AFTER HAND CYCLING the action a half dozen times and then carefully removing the slide to examine the spring's resting position. I took this photo to document the problem and to show how the spring pops completely out of the retained position when the action is cycled.

I have further written the explanation on the photo of the spring itself and have ADDED CAPTIONS to several other photos.

https://www.dropbox.com/sh/feh3h8xusxond28/R12IwAMjHK



Thanks
JohnneBush

Last edited by JohnnieBush; October 19, 2012 at 08:21 AM.
JohnnieBush is offline  
 
Page generated in 0.04479 seconds with 7 queries