Thread: Scope question
View Single Post
Old October 18, 2012, 10:22 AM   #8
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,584
Unless the rifle has bases integral with the receiver, it's no big deal to place equal-sized shims under both front/rear scope bases, just thick enough to raise the scope the 1/32" or less needed for the flip-up cover's base ring to slide between the scope & the barrel.

Installing a BCS (beer can shim) oughta do it.


.
PetahW is offline  
 
Page generated in 0.04288 seconds with 7 queries