View Single Post
Old October 13, 2012, 01:13 PM   #36
the led farmer
Senior Member
 
Join Date: July 8, 2012
Posts: 116
Quote:
3- Pull case out, wonder why the old primer is stuck in the "holder thing" and not falling into the tube.
do you have the lever prime in the ram (the thing that holds the primer)? plop that thing in there you need it when depriming

Quote:
7- Realize that each round, the shoulder (near the bullet) is getting smashed, creating a lip on the case.
here you are buckling the shoulder. the culprit is your bullet seating die/crimp die is improperly set up. you are forcing too much brass into the crimp ring causing the shoulder to fail so you get buckling like a mushroom tip.

you gotta back off die a bit and re-adjust

check these videos out if you haven't already Lee Die Adjustment

Last edited by the led farmer; October 13, 2012 at 01:25 PM.
the led farmer is offline  
 
Page generated in 0.04382 seconds with 7 queries