View Single Post
Old October 11, 2012, 06:22 PM   #4
iraiam
Senior Member
 
Join Date: September 6, 2012
Location: Lakewood, CO
Posts: 864
before I had an actual primer pocket swager, I used a 2 rod system that I called my redneck swager.

one rod went through the neck of the case and was long enough to touch the bottom of the case and stuck out a few inches, this end went in the vice.

The other rod was just a cold steel punch that I ground by hand on a benchtop grinder to be the right size, it was also tapered because all I wanted to do is remove the crimp at the base not resize the pocket.

I just put the one rod in in a vice stuck a case on it and lightly tapped the other rod into the primer pocket with a small hammer, crimp removed.
__________________
NRA Lifetime Member Since 1999

"I ask, sir, what is the militia? It is the whole people except for a few public officials." George Mason
iraiam is online now  
 
Page generated in 0.04003 seconds with 7 queries