View Single Post
Old October 11, 2012, 05:16 PM   #33
Misssissippi Dave
Senior Member
 
Join Date: December 5, 2009
Posts: 1,407
One thing I do with a new powder measure is to wipe it down with a dryer sheet. Bounce or any other anti static type should do. I like them to help remove any static there might be especially when there is plastic involved. After that I operate them a few times to dump any foreign matter before adding powder. Once the powder is in it dump a few just to settle things down a bit. After that you can start to see about getting it set for the amount of powder you want to get. There are some people that put graphite in there new powder measure and then keep dumping it to season the measure.
Misssissippi Dave is offline  
 
Page generated in 0.04765 seconds with 7 queries