View Single Post
Old October 11, 2012, 02:07 PM   #5
Bob Wright
Senior Member
 
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 1,815
I have never been able to do this, but thought about it several times:

Obtain a laser cartridge that fits the chamber of your gun. Load the "cartridge" with it turned on. Clamp your revolver in a sturdy tripod or other mount, and place a level across the sights so it rests on the top of the rear sight and top of the front sight blade, then level the bubble.(Assuming the sights are aligned with a bullseye at some range) It would be interesting to see where the laser is directed. Note line of sightand line of bore are not parallel.

This after the revolver (or pistol) is sighted in for a particular load.

Bob Wright

Last edited by Bob Wright; October 11, 2012 at 02:14 PM.
Bob Wright is offline  
 
Page generated in 0.04928 seconds with 7 queries