View Single Post
Old October 10, 2012, 08:22 PM   #8
CommonSense
Member
 
Join Date: August 1, 2012
Posts: 33
I meant the stock was made of polypropalyene, Yeah nothing on earth apparently adheres to it. I am looking to try to screw a block to it after putting something for the screws to bite to inside the stock like your saying... another block r something, then probably use little screws on the outside where the cheek piece will be and adjusting height on those until i feel comfortable that their height wont protrude beyond the surface and let those be what the epoxy adheres to. I stil want to be able to take some off in order to get the exact fit to the stock I'm looking for. I will update yall on the finished product! Thanks for the input. Oh, by the way, imput is ALWAYS still welcome!!
CommonSense is offline  
 
Page generated in 0.05288 seconds with 7 queries