View Single Post
Old October 10, 2012, 11:30 AM   #5
CommonSense
Member
 
Join Date: August 1, 2012
Posts: 33
I read some other posts about kitty hair not adhering to polyurathane based plastics, something about during the molding process at the factory there being a "releasing agent" inside the actual stock that when in contact with certain solvents and/or heat, say from a catalyst, it has been known to come to the stock's surface and cause poor adhesion...any knowledge of this?
CommonSense is offline  
 
Page generated in 0.04875 seconds with 7 queries