Thread: AR DIY'ers!
View Single Post
Old October 7, 2012, 10:05 PM   #2
BerdanSS
Senior Member
 
Join Date: April 3, 2011
Location: to close to other houses
Posts: 915
Make sure...this is important now....make sure the charging handle is a BCM gunfighter

Not really..as long as the head space is good...all manufacturing gunk (cutting oil, grease other crap) is cleaned for sure from the barrel, feed ramp and receivers...good to go. Make sure the gas block is on good (if applicable). Buddy of mine didn't crank the set screws down on his very good while building and on it's maiden voyage, it became a single shot after round four I believe...very disappointing range day for him.
BerdanSS is offline  
 
Page generated in 0.06090 seconds with 7 queries