View Single Post
Old October 7, 2012, 02:40 PM   #2
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 11,391
Yes,

I use Dillon spray lube...( even though I use all carbide dies / lubing makes the press run a lot smoother).

I get a box lid / for a large box...like a case of copy paper box ...so the box lid is a couple of inches deep - and about 11" X 17". I grab 4 or 5 handfulls of cleaned and sorted cases....and I dump them in the box lid ...then I roll them around so they're all flat / laying down. I spritz all the cases ( lightly ) with the lube. I roll them around / rub them in my hands ....and then let them dry for 20 min. They are now all set to run....

Its way easier - than those lube pads, all that stuff we used to use on single stage operations...
BigJimP is offline  
 
Page generated in 0.03902 seconds with 7 queries