View Single Post
Old October 6, 2012, 08:55 AM   #4
Hunter Customs
Senior Member
 
Join Date: March 26, 2005
Location: Osborn, Missouri
Posts: 1,731
Quote:
The Redding and Lee push through dies resized the case all the way down, but once the case has been thinned by the bulge, there's no way to re-thicken the brass, and the case is not as strong as a factory new case.
The above words are very true and I've seen this resized bulge brass blow.
I only reload 40 brass that was factory loads that I shot in fully supported barrels.

Best Regards
Bob Hunter
www.huntercustoms.com
Hunter Customs is online now  
 
Page generated in 0.04867 seconds with 7 queries