View Single Post
Old October 5, 2012, 08:39 PM   #17
USMCGrunt
Senior Member
 
Join Date: February 27, 2000
Location: Somewhere in 13T EG
Posts: 629
Well, the combo tool tends to work pretty well on my rifles but you may need to go with a 7/16" box end wrench if you really need the torque. I also use a gas cylinder wrench as well to prevent any unnecessary torquing on the barrel. Once you do get it off, you might want to use a bit of anti-sieze grease on the threads to prevent this problem from happening again. Good luck.
USMCGrunt is offline  
 
Page generated in 0.04067 seconds with 7 queries