The Firing Line Forums - View Single Post - thinking of a box mag on my rem 700 short action

Rob228 · October 5, 2012, 12:13 AM

I went with Badger, but it was really pricey. I also found out that Badger bottom metal doesn't go well with an H&S stock. Managed to make it all work but next time I'm going with a gunsmith, it took way too much cutting then way too much filling to make it both work and look nice. It does work though.

Also keep in mind, if you are going with Badger, or any of the systems that take AI magazines, they are about $100 a piece.

Here is my Rem 700 VLS with my wife behind the trigger.

October 5, 2012, 12:13 AM	#15
Rob228 Senior Member Join Date: May 29, 2010 Location: Broomfield CO Posts: 468	I went with Badger, but it was really pricey. I also found out that Badger bottom metal doesn't go well with an H&S stock. Managed to make it all work but next time I'm going with a gunsmith, it took way too much cutting then way too much filling to make it both work and look nice. It does work though. Also keep in mind, if you are going with Badger, or any of the systems that take AI magazines, they are about $100 a piece. Here is my Rem 700 VLS with my wife behind the trigger.