View Single Post
Old October 4, 2012, 02:48 PM   #6
FiveInADime
Senior Member
 
Join Date: January 25, 2012
Posts: 360
The screws that hold the trigger group to the action were probably not tightened well in the initial assembly of the rifle and worked loose over time. Just retighten the screws and maybe put a tiny spot of nail polish on the threads. Disassembly is straight forward. Just unscrew the 3 screws on the bottom of the rifle and the stock falls off. When re-tightening the screws dont go overboard just give it a nice snug twist and dont risk messing anything up. Ideally you would use an inch/lbs. torque wrench to get the screws perfectly tightened to their specs, but most dont have one.
FiveInADime is offline  
 
Page generated in 0.04550 seconds with 7 queries