View Single Post
Old October 3, 2012, 09:25 PM   #8
langenc
Senior Member
 
Join Date: August 19, 2007
Location: Montmorency Co, MI
Posts: 1,187
Stock screws dont need to be very tight. I used to get a good sized driver and give it most of what I had.

No more. Now I tighten jst a little. If you have a torque driver--front 50-55 INCH pounds-rear about 30-35 INCH pounds.

Tighten both kinda alternating and then tighten the final torque-the front screw first then the rear.

With a good sized driver it is possible to go WAY over the numbers mentioned above.
langenc is offline  
 
Page generated in 0.04336 seconds with 7 queries