View Single Post
Old October 3, 2012, 03:04 PM   #4
Bob Wright
Senior Member
 
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 1,857
The edges of the slotted area of the ejector rod housing of most single actions are sharp and will slice your finger tips if you ride your finger along that surface when ejecting.

As to the face of the cylinder, sounds as if you have a build up of lead and lubricant, which should wipe off fairly easily. Most revovlers get this build up on the cylinder face when using cast bullet loads. Nothing to worry about.

Bob Wright
Bob Wright is offline  
 
Page generated in 0.04115 seconds with 7 queries