View Single Post
Old October 1, 2012, 01:03 PM   #9
hooligan1
Senior Member
 
Join Date: July 18, 2010
Location: Independence Missouri
Posts: 3,257
Quote: Its the firing of the round that expands the brass, not seating the bullet....

Well let me tell you a story...........

About a year ago I decided that the 150 grn Swift Sirroccos were not going to group like I'd hoped for,,, so I pulled 15 bullets and poured the powder back in the can ans set the cases on the shelf until one day I came up with a new bullet to try in my 7mm rem mag, the 140 grn Accubond, as it turns out there IS a slightly difference in these two bullets,,, cause after I loaded a few they just would not pass the Thumb Pressure on the ole bench Test, after posting my said troubles on this forum another member pointed out to me that I could take my expander ball and primer pin out of my die and resize the casemouth, and it worked to perfection of course.( thanks Taylorce1)
__________________
Thanks for coming!
hooligan1 is offline  
 
Page generated in 0.05679 seconds with 8 queries