View Single Post
Old September 30, 2012, 12:13 PM   #4
buck460XVR
Senior Member
 
Join Date: December 28, 2006
Posts: 2,068
Even if it is flame cutting, revolvers are prone for it. Nature of the beast. Even with magnum handguns it goes so far and then eventually stops. I have yet to see a topstrap even close to being damaged to the point of being unsafe by flame cutting except in the case of lightweight alloy or polymer framed guns with a separate flame shield. This is not the case here.
buck460XVR is offline  
 
Page generated in 0.04787 seconds with 7 queries