View Single Post
Old September 30, 2012, 09:13 AM   #12
Tom Servo
Staff
 
Join Date: September 27, 2008
Location: Foothills of the Appalachians
Posts: 10,054
Quote:
When I was working for the gun shop in the early 1990s we sent quite a few back to the factory that had front sight cants of 10 degrees, or worse.
That still happens, but it's very rare. I've seen it twice in the last 8 years.

Quote:
The difference is in the amount of torque used to tighten the barrel down
Thanks for the clarification. I've heard a number of differing opinions about the definition of "crush fitting" over the years.
__________________
In the depth of winter I finally learned that there was in me an invincible summer.
--Albert Camus
Tom Servo is offline  
 
Page generated in 0.04154 seconds with 7 queries