View Single Post
Old September 30, 2012, 12:25 AM   #20
AZGlock13
Senior Member
 
Join Date: May 10, 2007
Location: AZ
Posts: 252
I bought the polished nickel SW1911 used, but what I found on the internet they appear to be the stock grips S&W put on that particular model (not too many of that model were made, as far as I can tell, but the few I seen on the Internet, have the same grips on them for that model). I have no idea what S&W called those grips. The only problem with them is that they are a bit on the slick side (not good if your hand starts getting sweaty).

Last edited by AZGlock13; September 30, 2012 at 12:32 AM.
AZGlock13 is offline  
 
Page generated in 0.04663 seconds with 7 queries